GPX Pro 8
© 2009 XT Racing
speed so the GPX knows when to start keeping track of the amount of time you are "stopped".
1.1.5 Menus
Set starting speed – the speed at which the GPX starts capturing data for circuit racing
Set stopping speed/time – how the GPX terminates capturing data for a session
Choose stopping method
Stop based on speed - the GPX stops capturing when you go below this speed
Stop based on time - the GPX stops capturing this many minutes after you go
below the "stop based on speed" speed (or when you press any key when
stopped)
Spinner options
Count laps
Count up – the lap counter starts at one and increases
Count down – the lap counter start at the specified count (see below) and counts
down
Set number of laps per session – used for “Count down”
Hold time at end of each lap – number of seconds your lap time will “freeze” on the
display at the end of each lap
Split hold time – number of seconds each split time will “freeze” on the display when you
pass the split
Track options
Track detection method
First loop – a new track will be detected as soon as a complete loop is detected
and the start/finish line will be set at that point
Longest straight – a new track will be detected as soon as a complete loop is
detected, but the start/finish line will be set 1-2 laps later, about 1/3 of the way
down the longest straightaway
Manual selection - you select via a menu which track you are racing at
Set the start/finish line of a new track – allows you to manually “create a new track” by
physically going to the start/finish line to register the GPS coordinate
Comments to this Manuals