Microlab PRO-1 Service Manual download pdf (Page 28)

MicroLab PC

28 Agilent MicroLab Software Operation Manual

Generating the method file

To generate the method file in MicroLab PC:

1 From the MicroLab PC Component Definition dialog box, enter a

component name. The component name is the text that will

appear next to the value when the method is run by the end user.

The name should be descriptive of the property being predicted.

2 For a multivariate (PLS) method, choose Quant Model as the

Calculation Type. An Open file dialog box will appear.

3 Choose the appropriate calibration text file (exported from

Galactic GRAMS in Step 7 of ‘Exporting the PLS/IQ *.CAL file to

ASCII’) and click Open.

4 Other options available in the Component dialog box are listed

below:

a Peak 1 and Peak 2: These set a frequency range to be

displayed when the component is selected from the Results

screen. If this is left blank, the entire spectrum is displayed.

b Scaling: The scaling section will apply a linear scaling to the

result generated from the Quant model.

c Thresholds: These values set the display colors for the

component result. If the component value is above or below

the critical values, the result will be displayed in red. If the

component value is between the critical and the marginal

values, the result will be displayed in yellow. Otherwise the

result will be displayed in green.

d Report Value As: Changes the display between an actual

component value, a % of the critical high value or a % of the

critical low value.

5 Once all of the values are set appropriately, click OK.

6 Click Save As. Enter the appropriate method name and save to

the folder: C:\Program Files\Agilent\MicroLab PC\Methods.

7 The method is now available for use with MicroLab PC. Ensure

that the method is Activated in order to use the method.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 49 50

No comments

Microlab PRO-1 Service Manual Page 28